- Here is a detailed description on how to run External mode for serial: Parameter Tuning and Signal Logging with Serial External Mode
- If using serial, you might find this page useful as well: Set Up Serial Communication with Target Hardware.
- If using an XDS100 based board (LaunchPad, controlCards, docking stations, TI evaluation boards, etc.), here is a useful page to setup the serial port of the XDS100: Using the serial adapter of XDS100
C2000 Embedded coder -- Change default time-out
조회 수: 2 (최근 30일)
이전 댓글 표시
Hi all,
I am trying to run a model in external mode, but keep getting the error " Unable to connect to the 'TI Delfino F2833x' target for ..." and " Error occurred while executing External Mode MEX-file 'ext_serial_win32_comm': Failed to connect to the target. A time-out occurred while waiting for the first connect response packet. Possible reasons for the time-out:"
When I type command ticcs into Command Window I get:
>> ticcs
TICCS Object:
Processor type : TMS320C28xx
Processor name : TMS320C2800_0
Running? : No
Board number : 0
Processor number : 0
Default timeout : 10.00 secs
RTDX channels : 0
If I reduce the number of elements in the model, I can connect. I suspect time-out is too low.
How to change time-out?
댓글 수: 0
채택된 답변
Antonin
2017년 3월 1일
Hi Mike,
Usually the External mode time out is more then enough and the fact that you hit it probably means that you have a connection problem. I'm not sure which version of MATLAB you are using and what connection you are trying to use. We support CAN and Serial for TI C2000.
I hope it helps,
Antonin.
댓글 수: 0
추가 답변 (0개)
참고 항목
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!