How do I connect a Joint spring-damper to a prismatic joint which is further connected to a mass in SimMechanics, without letting two masses disconnect.?
조회 수: 4 (최근 30일)
이전 댓글 표시
Hello, I am trying to model a system that consisting of mass(which is in motion in x direction)- (spring &damper in x direction) - mass - (spring and damper in z direction) using simmechanics. While putting a joint spring and damper on a prismatic, it disconnects and the masses moves at separate velocity. Is this a normal situation ? I have been trying to fix things a lot. Now, suppose I use a revolute joint the masses stay connected, but not with the prismatic joint.
댓글 수: 2
Ari
2017년 6월 30일
Can you provide a rough sketch of how the massses and SMDs are connected along with which is the x and z directions?
답변 (1개)
Steve Miller
2019년 4월 3일
Hi - without the model, it is very hard to give you a good suggestion.
Some things it could be:
- Springs were too weak, and gravity pulls them far apart.
- Your did not properly attach the mechanism to ground
If you share the model we may be able to give better advice.
--Steve
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Assembly에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!