TI DSP 28377D HOW TO RUN A MODEL
조회 수: 7(최근 30일)
I have created the attached model to run on a texas Instruments DSP DELFINO 28377D.
Do you know how to run the generated code on the DSP??? Do I need to use code composer?? I Have clicked on Deploy to hardware on Simulink and this is the answer I get,
however I don't know how to proceed and run the code on Code Composer 6. I also attach my simulink model.
Michael 2016년 4월 26일
are there any new on this topic? Have exactly the same problem. Connection with CCS works fine, but not with Simulink.
Kind regards Michael
Rohit Jain 2016년 3월 2일
I think the below link would be useful for you:
Hope this helps.
Sumith Sekharan 2016년 3월 15일
MATLAB is using CCS Debug Server to load code to the target hardware. From the error message, it looks like connection to the F2377D is failed. There are few things to verify:
- Ensure you can connect to the board using CCS.
- If you cannot connect using CCS, please try to update the CCS software to get F28377D support. You may be missing the hardware configuration files for F28377D processor.