How to send a Notify with Simulink Arduino BLE send?

조회 수: 6 (최근 30일)
Sylvain
Sylvain 2023년 3월 10일
댓글: Sylvain 2023년 7월 11일
I am trying to sense a POLAR H10 heart rate strap.
I need to send notify flag to the server,
Here is my simulink program. If anyone has some suggestion, please let me know

답변 (1개)

Atharva
Atharva 2023년 6월 22일
Hey Sylvain,
To send a notify flag to the server using Simulink and Arduino with BLE (Bluetooth Low Energy), you can follow these general steps:
  1. Set up the hardware:
  • Connect your Arduino board to your computer.
  • Make sure your Arduino board has a Bluetooth module that supports BLE communication (e.g., HM-10 or HM-11).
  • Install the required libraries for Arduino BLE communication (e.g., ArduinoBLE library).
  1. Create a Simulink model:
  • Launch Simulink and create a new model.
  • Add the necessary blocks for Bluetooth communication.
  • Configure the blocks to establish a BLE connection with your heart rate strap.
  • Set up the characteristics and services to enable notifications from the heart rate strap.
  1. Implement the notify flag:
  • Add a logic block in Simulink that sets the notify flag based on your desired conditions.
  • Connect the output of the logic block to the Bluetooth block responsible for sending notifications.
  1. Configure and run the Simulink model:
  • Configure the Bluetooth blocks with the appropriate settings, such as the heart rate strap's device name or MAC address.
  • Configure the communication parameters for your specific heart rate strap (e.g., UUIDs for characteristics and services).
  • Connect your Arduino board to your computer and upload the Simulink model to it.
  • Run the Simulink model, which will start the BLE connection and send notifications based on the notify flag.
It's important to note that the specific implementation details may vary depending on your heart rate strap and the BLE module used on your Arduino board. Consult the documentation and resources provided by the heart rate strap manufacturer and the Arduino BLE library for more detailed instructions on setting up the BLE communication and implementing notifications. Remember to adapt the Simulink model and Arduino code according to your specific requirements and the BLE capabilities of your heart rate strap.
  댓글 수: 1
Sylvain
Sylvain 2023년 7월 11일
I had another try, but I am not succeful, I will see if i can do a direct Arduino code on my ardware, see if this works on its own

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 Modeling에 대해 자세히 알아보기

제품


릴리스

R2022b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by