How to simulate in function of duty cycle instead of time?
조회 수: 13 (최근 30일)
이전 댓글 표시
Pedro José Servián García
2022년 9월 27일
댓글: Pedro José Servián García
2022년 11월 20일
Dear colleagues,
I'm doing the bachelor thesis about using dc-dc converters with PV Panels. See 1st photo
When I run the model it run in function of time, but I would like to do a simulation with the duty cycle in the Scopes. I mean, to show the output values when the converter works with different duty cycle (I don't care about time).
I don't know how to do it and I would be very grateful if you could give me a clue or a help with that.
Thank you in advance.
댓글 수: 0
채택된 답변
Joel Van Sickel
2022년 9월 28일
Hello Pedro,
To do this live, you can use the x/y graph: https://www.mathworks.com/help/simulink/ug/plot-circle-with-xy-graph.html
It might be a bit noisy, if you want to post process the data to remove noise, please see below.
To do this with clean data, you'll only want the steady state solution. I would model the system in time, and step it through a few discrete duty cycles, for instance, 0.1, 0.2, 0.3, 0.4, 0.5, etc. Then you can take the steady state operating point for each duty cycle and plot that vs duty cycle. This will require creating a matlab script to post process the data and plot it after the simulation has run.
Regards,
Joel
댓글 수: 3
Joel Van Sickel
2022년 11월 17일
Hello Pedro, unfortunately, I don't know a tool that will automatically do it. What I would do is use this block: https://www.mathworks.com/help/simulink/slref/toworkspace.html
then, at fixed time intervals, change your duty cycle. You can then grab the data from the moment before you change your duty cycle and that will be your steady state result if the system has been given enough time to hit steady state.
추가 답변 (0개)
커뮤니티
더 많은 답변 보기: Power Electronics Community
참고 항목
카테고리
Help Center 및 File Exchange에서 Electrical Block Libraries에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!