Simulink External mode crashes while running on TI F28379D Launchpad

조회 수: 4 (최근 30일)
Michael Nye
Michael Nye 2022년 5월 19일
I am using a TI F28379D Launchpad as a motor controller. I will run my controller model in external mode on the launchpad, and it will upload and start to run. Often, the model will randomly crash while in external mode and will stop communicating with the Launchpad. I will get the following error:
External Mode Open Protocol CheckData command failed
Caused by:
  • Multiple errors detected.
  • XCP serial port error: serial port send error
  • Error detected while trying to disconnect Simulink from target application.
  • Could not disconnect from target application: XCP serial port error: serial port send error
What does this mean? How do I fix it?

이 질문에 답변하려면 로그인하십시오.

답변 (0개)

카테고리

Help Center 및 File Exchange에서 Texas Instruments C2000 Processors에 대해 자세히 알아보기

태그

제품


릴리스

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by