Spring and Damper ForceのNatural Lengthを0にしたいです

조회 수: 1 (최근 30일)
taichi muto
taichi muto 2022년 1월 7일
댓글: taichi muto 2022년 1월 12일
Spring and Damper ForceのNatural Lengthの値を0にして剛体同士を引き付けているのですが、剛性や減衰係数を変えても0になりません。
0.002などの0に近い値に収束してしまいます。
この値は完全な0にはならないのですか?それとも何か他の原因があるのでしょうか?

채택된 답변

Toshinobu Shintai
Toshinobu Shintai 2022년 1월 8일
편집: Toshinobu Shintai 2022년 1월 8일
「Spring and Damper Force」ブロックはジョイントで接続された剛体間にバネダンパーを持たせるためのブロックです。例えば添付ファイルのようにモデリングします。
「Natural Length」は簡単に言うと、"初期位置の時点でバネがどのくらい伸縮しているか"を指定するパラメータです。モデルを見ていないので分かりませんが、その"0.002などの0に近い値"というのが、力学的に釣り合いのとれた距離なのではないでしょうか。
  댓글 수: 5
Toshinobu Shintai
Toshinobu Shintai 2022년 1월 12일
解決したようで、良かったです。
私のざっくりとした表現よりかは、ドキュメントの記述の方が正確ですので、ドキュメントを参照していただこうと思って、上記を記載しました。
Natural Length
Enter the equilibrium distance between the base and follower frame origins. This is the distance at which the magnitude of the spring force is zero. The default value is 0. Select or enter a physical unit.
taichi muto
taichi muto 2022년 1월 12일
Toshinobu Shintaiさんの表現も大変参考になりました。
この度はありがとうございました。

댓글을 달려면 로그인하십시오.

추가 답변 (0개)

카테고리

Help CenterFile Exchange에서 アセンブリ에 대해 자세히 알아보기

제품


릴리스

R2020a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!