How to model a two phase pipe system under vacuum pressure?

조회 수: 1 (최근 30일)
Delika Weragoda
Delika Weragoda 2021년 10월 28일
편집: Delika Weragoda 2021년 10월 28일
I'm trying to model a two phase flow through a pipe network with an inital pressure (vacuum) of 3.5kPa. Two receiver-accumulator blocks are also used to model evaporation and condensation. However, even after setting the initial conditions to 3.5kPa and a intial temperature of 300K, the internal pressure goes up to about 6MPa. Because of this increase there is no phase change in the system as well. I'm not sure if an external vacuum pressure needs to be introduced to the system to model a vacuum sealed pipe system. I would be really grateful if someone could point out any alternatives or mistakes I've made.
Please see the subsystem below
Many thanks

답변 (0개)

카테고리

Help CenterFile Exchange에서 Two-Phase Fluid Library에 대해 자세히 알아보기

제품


릴리스

R2020a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by