daq.Vendors returns 'Operational' attribute of 'mcc' as false

조회 수: 4 (최근 30일)
I am using a MCC data acquisition hardware. I have downloaded the correspoding support package. But when I run the “daq.getVendors” command, the “Operational” column of the “mcc” row is “false”. I could connect to the device through MCC’s InstaCal utility. How could I solve this? 

채택된 답변

MathWorks Support Team
MathWorks Support Team 2021년 9월 15일
MATLAB Data Acquisition Toolbox requires certain version of MCC driver to work. And this particular version of driver is normally installed along with the support package. You might see that during the installation of the support package, it will tell you that a third-party software is downloaded, and that is the driver with the required version. But if you already have a driver, which could be any version, installed on your machine, the support package installation might skip the driver installation step. That will cause incompatibility, which might introduce unexpected behavior. 
 Please try the following steps and see if it helps: 
  1. Uninstall the support package. 
  2. Uninstall the MCC software. 
  3. Install the support package again, and the right version of MCC software will be installed along with it 
  4. Restart machine 

추가 답변 (0개)

카테고리

Help CenterFile Exchange에서 Introduction to Installation and Licensing에 대해 자세히 알아보기

제품


릴리스

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by