Supported EDA Tools and Hardware

Software

Xilinx Vivado and ISE

Use this support package with these recommended versions:

  • Xilinx® Vivado® 2018.2

  • Xilinx ISE 14.7

    • Xilinx ISE is not supported for FPGA data capture or MATLAB® AXI master.

    • Xilinx ISE is required for FPGA boards in the Spartan®-6, Virtex®-4, Virtex-5, and Virtex-6 families.

For tool setup instructions, see Set Up FPGA Design Software Tools (HDL Verifier).

Board Connections

JTAG Connection

You can run FPGA-in-the-loop, FPGA data capture, or MATLAB AXI master over a JTAG cable to your board. However, each feature requires exclusive use of the JTAG cable, so you cannot run more than one feature at the same time. To allow other tools access to the JTAG cable, such as programming the FPGA, and Xilinx ChipScope, you must discontinue the JTAG connection in MATLAB. To release the JTAG cable:

  • FPGA-in-the-loop — Close the Simulink® model, or call the release method of the System object™.

  • FPGA data capture — Close the FPGA Data Capture app, release the System object, or close the Simulink model.

  • MATLAB AXI master — Call the release method of the object.

For Xilinx boards, the JTAG clock frequency is 33 or 66 MHz. The JTAG frequency depends on the type of cable and the maximum clock frequency supported by the FPGA board.

Required HardwareRequired Software

Digilent® download cable.

  • If your board has an onboard Digilent USB-JTAG module, use a USB cable.

  • If your board has a standard Xilinx 14 pin JTAG connector, you can obtain an HS2 or HS3 cable from Digilent.

  • For Windows® operating systems: Xilinx Vivado executable directory must be on system path.

  • For Linux® operating systems: Digilent Adept2

FTDI USB-JTAG cable

  • Supported for boards with onboard FT4232H or FT2232H devices, implementing USB-to JTAG

Supported for Windows operating systems.

Note

FTDI USB JTAG support is only available for MATLAB as AXI Master and for FPGA Data Capture.

Ethernet Connection

You can run FPGA-in-the-loop over an Ethernet connection.

Required HardwareSupported InterfacesRequired Software
  • Gigabit Ethernet card

  • Cross-over Ethernet cable

  • FPGA board with supported Ethernet connection

  • Gigabit Ethernet — GMII

  • Gigabit Ethernet — RGMII

  • Gigabit Ethernet — SGMII

  • Ethernet — MII

There are no software requirements for an Ethernet connection, but ensure that the firewall on the host computer does not prevent UDP communication.

Note

Ethernet connection to Virtex-7 VC707 not supported for Vivado versions older than 2013.4.

PCI Express

FPGA-in-the-loop over a PCI Express® connection is supported only for 64-bit Windows operating systems.

BoardRequired Software
  • Kintex®-7 KC705 Evaluation Kit

  • Virtex -7 VC707 Evaluation Kit

  • Xilinx Virtex-7 VC709 Evaluation Board

  • Virtex UltraScale+™ FPGA VCU118 Evaluation Kit

Vivado 2017.4

Related Topics