Hardware and Software Requirements

Supported Hardware

The Communications Toolbox™ Support Package for USRP® Radio supports the following boards from Ettus ResearchTM:

  • USRP2®

  • USRP® Networked Series (N210, N200), referred to in this documentation as N2xx

  • USRP® Bus Series (B200 and B210*), referred to in this documentation as B-series

  • USRP® X Series (X310*, X300*), referred to in this documentation as X3xx

* SISO and 2x2 MIMO modes are supported.

The Support Package for USRP® Radio has been tested on these devices using supported daughterboards (see Supported Daughter Cards). Support might also extend to other UHD-based radios and daughterboards from Ettus ResearchTM.

Supported Daughter Cards

  • DBSRX

  • DBSRX2

  • LFRX

  • LFTX

  • SBX

  • TVRX

  • TVRX2

  • WBX

  • XCVR2450

These daughter cards are used with the following radios: USRP2®, USRP® Networked Series (N210, N200), USRP® X Series (X310, X300). Support might also extend to other UHD-based radios and daughterboards from Ettus ResearchTM.

Firmware

The blocks and System objects use a specific version of the UHD driver. The FPGA binaries on your USRP® radio must match the specific version of the UHD drivers supported by the current release.

MathWorks Products

The following MathWorks products are required for using Communications Toolbox Support Package for USRP Radio.

  • MATLAB®

  • Communications Toolbox

  • DSP System Toolbox™

  • Signal Processing Toolbox™

  • Communications Toolbox Support Package for USRP Radio

Recommended Products

  • Simulink®

  • HDL Coder™

Related Topics