Writes PWM duty cycle to PWM pin
The PWM uses a software implementation allowing all GPIO pins on the Raspberry Pi™ hardware board to operate as a PWM pin. Each PWM pin outputs a square
waveform with variable frequency, duty cycle, or average voltage. A duty cycle of
0 means the waveform is always low and a duty cycle of
1 means the waveform is always high.
To use a PWM pin, reconfigure one of the multiple-use GPIO pins as a PWM pin.
dutyCycle — Duty cycle of output waveform
Duty cycle between
1 to assign to
Enable PWM and Set Properties
Enable PWM pin 12 and set the frequency and duty cycle.
mypi = raspi(); configurePin(mypi, 12, 'PWM'); writePWMDutyCycle(mypi, 12, 0.5); writePWMFrequency(mypi, 12, 2000);
The result is a square wave with a 50.0% duty cycle, frequency of 2000 hertz,
and average voltage of
C/C++ Code Generation
Generate C and C++ code using MATLAB® Coder™.
You can also deploy
writePWMDutyCycleon the Raspberry Pi hardware in MATLAB® Online™.
Introduced in R2016b