Standard Servo Read
Measure shaft position of standard servo motor in degrees
Simulink Support Package for Arduino Hardware / Common
The Standard Servo Read block measures the shaft position in degrees of the standard servo motor interfaced with the Arduino® hardware board.
If you use the Standard Servo Read block along with the Serial Receive and Serial Transmit blocks in a Simulink® model, use longer sample times to avoid overruns.
Maximum Number of Servo Blocks Allowed Per Simulink Model
The number of Servo blocks, Standard Servo Read, Standard Servo Write, and Continous Servo Write, you can use in your Simulink model depends on the number of timers on your Arduino hardware board. Every timer on the Arduino board can support up to 12 Servo blocks.
For example, consider the Arduino Mega 2560/ADK board. The maximum number of servo
blocks that can be used per Simulink model is 48. If your Simulink model utilizes a total number of 48 Servo blocks and the board has 5 timers,
timer 5 supports the first set of 12 (1 to 12) Servo blocks. Similarly, timer 1 supports the
next set of 12 (13-24) Servo blocks, timer 3 supports the next set of 12 (25-36) Servo
blocks, and finally, timer
4 supports the last set of 12 (37-48) servo
The Servo blocks are grouped as follows:
Set 1: Servo blocks 1 to 12
Set 2: Servo blocks 13 to 24
Set 3: Servo blocks 25 to 36
Set 4: Servo blocks 37 to 48
Set 5: Servo blocks 49 to 60
This table shows how to assign timers to Servo blocks depending on the Arduino board you are using. It also provides the maximum number of Servo blocks that you can use per Simulink model.
|Arduino Board Type||Timer||Maximum Number of Servo Blocks Per Simulink Model|
|Uno, Nano 3.0||1||Set 1|
|Mega 2560/ADK||1||Set 2|
|Leonardo, Robot Control Board, Robot Motor Board, Micro||1||Set 1|
|MKR 1000, MKR Wifi 1010, MKR Zero||TC4||Set 1|
|Nano 33 IoT||TC4||Set 1|
Data — Standard servo motor shaft rotation angle
positive integer in the range [
The block outputs the shaft rotation angle from
180 degrees for the standard servo motor that you interface with
the Arduino hardware board. When simulating without the hardware, the block outputs
Pin number — Standard servo read pin number
2 (default) | scalar
Specify the Arduino hardware board pin number to which the standard servo read motor input signal is connected.
Do not assign the same pin number to multiple blocks within a Simulink model.
For more information on how to assign pins or view the pins for the Standard Servo Read block, see Pin Mapping for Arduino Timer Dependent Blocks.
Sample time — Time interval at which block reads shaft rotation data
0.1 (default) | scalar
Enter the time interval in seconds at which the block reads the shaft rotation angle
of the standard servo motor. The minimum sample time is
View Pin Map — Open pin mapping for Arduino hardware boards
Click this button to view the pin mapping table associated with the Arduino hardware board you select.
Introduced in R2012a
Standard Servo Write | Continous Servo Write | PWM | Install Support for Arduino Hardware | Pin Mapping for Arduino Timer Dependent Blocks | Conflicting Pin Configurations on Arduino Timer | Model Configuration Parameters for Simulink Support Package for Arduino Hardware