Measure voltage in circuit
Simscape / Electrical / Specialized Power Systems / Fundamental Blocks / Measurements
The Voltage Measurement block measures the instantaneous voltage between two electric nodes. The output provides a Simulink® signal that can be used by other Simulink blocks.
v— Instantaneous voltage measured between + and - conserving ports
Outputs the instantaneous voltage measured between the + and - conserving ports, specified as a scalar.
+— Positive terminal
Specialized electrical conserving port associated with the positive terminal of the Voltage Measurement block.
-— Negative terminal
Specialized electrical conserving port associated with the negative terminal of the Voltage Measurement block.
Output signal— Output signal format
Specifies the format of the output signal when the block is used in a phasor simulation.
Complex to output the measured current
as a complex value. The output is a complex signal.
Real-Imag to output the real and
imaginary parts of the measured current. The output is a vector of two
Magnitude-Angle to output the magnitude
and angle of the measured current. The output is a vector of two elements.
Magnitude to output the magnitude of the
measured current. The output is a scalar value.
To enable this parameter, set the Simulation type
parameter of the powergui block to