기본

커패시터, 저항기, 인덕터와 같은 기본적인 패시브 컴포넌트

기본적인 패시브 컴포넌트를 사용하여 사용자 지정 전자 모델을 빌드합니다.

Simscape 블록

Capacitor	Linear or nonlinear capacitor with optional tolerance, operational limits and fault behavior
Constant Current Load	Constant current load for DC or AC supply (R2021a 이후)
Constant Current Load (Three-Phase)	Three-phase constant current load (R2021a 이후)
Constant Power Load	Constant power load for DC or AC supply (R2020a 이후)
Constant Power Load (Three-Phase)	Three-phase constant power load (R2020b 이후)
Crystal	Stable resonator
Diffusion Resistor	Resistor model with velocity saturation and optional tolerance, operational limits, fault behavior, and noise
Dynamic Load	Dynamic load for DC or AC supply (R2020b 이후)
Dynamic Load (Three-Phase)	Balanced three-phase dynamic load
Eddy Current	Eddy current loss representation
Incandescent Lamp	Incandescent lamp with temperature dependent resistance
Inductor	Inductor including optional tolerance, operational limits and fault behavior
Nonlinear Inductor	Inductor with nonideal core
Nonlinear Reluctance	Nonlinear reluctance with magnetic hysteresis
Passive Harmonic Filter (Three-Phase)	Harmonic current filter (R2019b 이후)
Potentiometer	Rotary or linear-travel potentiometer controlled by physical signal
Resistor	Resistor including optional tolerance, operational limits, fault behavior, and noise
Supercapacitor	Electrochemical double-layer capacitor
Variable Capacitor	Linear time-varying capacitor
Variable Gap Capacitor	Capacitor with parallel plates and variable gap (R2023b 이후)
Variable Inductor	Linear time-varying inductor
Varistor	Voltage-dependent resistor
Winding	Electromagnetic converter with ohmic and magnetic flux losses

도움말 항목

Parameterizing Blocks from Datasheets
Overview of techniques used to specify block parameters to match the data from manufacturer datasheets.

추천 예제

AC Cable with Bonded Sheaths

A three-phase cable model comprised of multiple pi-sections. Each phase is enclosed in a conductive sheath. The conductive sheath is connected to ground at either end of the cable through a simple resistance. A high-voltage source provides power to an unbalanced resistive load through the power cable. You can configure the sheath to be either series-bonded or cross-bonded. You can also configure the number of pi-sections. Increasing the number of pi-sections improves the accuracy but slows down the simulation. To facilitate convergence, the voltage source includes an internal impedance.

모델 열기

Tap-Changing Transformer for Automatic Voltage Regulation

Use a single-phase tap-changing transformer to control the voltage across an RLC load. The system contains an AC voltage source that generates a 60 Hz sine wave (located on the left-hand side of the circuit). The root-mean-square value for the voltage generated by this source is 120 V (reference voltage).

모델 열기