Hydraulic variable orifice at intersection of two holes
The Variable Orifice Between Round Holes block models a variable orifice created by two interacting round holes. These holes can have different diameters. One hole is located in the sleeve, while the other is drilled in the case, with the sleeve sliding along the case. Such a configuration is frequently seen in cartridge valves, as shown in this 3-way valve schematic.
The block can contain multiple identical interacting pairs of holes. The following schematic shows the calculation diagram for one such pair of round holes, where
|s||Sleeve displacement from initial position|
|c||Distance between hole centers|
|ds||Sleeve hole diameter|
|dc||Case hole diameter|
The flow rate through the orifice is proportional to the orifice area and to the pressure differential across the orifice, according to these equations:
|pA, pB||Gauge pressures at the block terminals|
|A||Instantaneous passage area between orifices|
|c||Instantaneous distance between hole centers|
|r||Smaller hole radius|
|R||Larger hole radius|
|z||Number of hole pairs|
|CD||Flow discharge coefficient|
|Aleak||Closed orifice leakage area|
|pcr||Minimum pressure for turbulent flow|
The minimum pressure for turbulent flow, pcr, is calculated according to the laminar transition specification method:
By pressure ratio — The transition from laminar to turbulent regime is defined by the following equations:
pcr = (pavg + patm)(1 – Blam)
pavg = (pA + pB)/2
|pavg||Average pressure between the block terminals|
|patm||Atmospheric pressure, 101325 Pa|
|Blam||Pressure ratio at the transition between laminar and turbulent regimes (Laminar flow pressure ratio parameter value)|
By Reynolds number — The transition from laminar to turbulent regime is defined by the following equations:
|ν||Fluid kinematic viscosity|
|Recr||Critical Reynolds number (Critical Reynolds number parameter value)|
The block positive direction is from port A to port B. This means that the flow rate is positive if it flows from A to B. Positive signal at port S moves the sleeve in the positive direction.
Inertial effects are not taken into account.
Diameter of the holes drilled in the sleeve. The default value is
Diameter of the holes drilled in the case. The default value is
Number of interacting hole pairs. The default value is
Semi-empirical parameter for orifice capacity characterization. Its value
depends on the geometrical properties of the orifice, and usually is
provided in textbooks or manufacturer data sheets. The default value is
Select how the block transitions between the laminar and turbulent regimes:
Pressure ratio — The transition
from laminar to turbulent regime is smooth and depends on the value
of the Laminar flow pressure ratio parameter.
This method provides better simulation robustness.
Reynolds number — The transition
from laminar to turbulent regime is assumed to take place when the
Reynolds number reaches the value specified by the
Critical Reynolds number parameter.
Pressure ratio at which the flow transitions between laminar and turbulent
regimes. The default value is
0.999. This parameter is
visible only if the Laminar transition specification
parameter is set to
The maximum Reynolds number for laminar flow. The value of the parameter
depends on the orifice geometrical profile. You can find recommendations on
the parameter value in hydraulics textbooks. The default value is
12. This parameter is visible only if the
Laminar transition specification parameter is set
The total area of possible leaks in the completely closed orifice. The
main purpose of the parameter is to maintain numerical integrity of the
circuit by preventing a portion of the system from getting isolated after
the orifice is completely closed. The parameter value must be greater than
0. The default value is
Parameters determined by the type of working fluid:
Fluid kinematic viscosity
The block has the following ports:
Hydraulic conserving port associated with the orifice inlet.
Hydraulic conserving port associated with the orifice outlet.
Physical signal port that provides the instantaneous value of the distance between the hole centers.