Scramble input signal
The Scrambler block scrambles a scalar or column vector input signal. If you set the Calculation base parameter to N, then the input values must be integers between 0 and N-1.
One purpose of scrambling is to reduce the length of s of 0s or 1s in a transmitted signal, since a long of 0s or 1s may cause transmission synchronization problems. Below is a schematic of the scrambler. All adders perform addition modulo N.
At each time step, the input causes the contents of the registers
to shift sequentially. The Scramble polynomial parameter
defines if each switch in the scrambler is on or off. Specify the
polynomial as a character vector,
'1 + z^-6 + z^-8'. Alternatively,
you can specify the polynomial by listing its coefficients in order
of ascending powers of z-1,
= 1 + p1z-1 + p2z-2+...,
or by listing the powers of z that appear in
the polynomial with a coefficient of 1. For example p =
[1 0 0 0 0 0 1 0 1] and p = [0 -6 -8] both represent
the polynomial p(z-1)
= 1 + z-6 + z-8.
The Initial states parameter lists the states of the scrambler's registers when the simulation starts. The elements of this vector must be integers between 0 and N-1. The vector length of this parameter must equal the order of the scramble polynomial. (If the Scramble polynomial parameter is a vector that lists the coefficients in order, then the order of the scramble polynomial is one less than the vector length). There is an optional port that can be used to reset the scrambler.
Alternatively, the initial states can be provided by an input
port when Initial states source parameter is
This block can accept input sequences that vary in length during simulation. For more information about sequences that vary in length, or variable-size signals, see Variable-Size Signal Basics in the Simulink® documentation.
The calculation base N. The input and output of this block are integers in the range [0, N-1].
A polynomial that defines the connections in the scrambler.
A drop down menu that controls the source of the initial states.
Dialog Parameter or
port. The default value is
The states of the scrambler's registers when the simulation
starts. This parameter is available when Initial states
source is set to
A check box that creates a reset port. When checked, the scrambler
is reset if a nonzero input is applied to the port. This control is
available when Initial states source is set to
Parameter. The default is that the box is not checked.